RKC INSTRUMENT CB100 Initial Setting Manual

1. TRANSFER TO MODE
IMCB04-E10
3
1.2 Exit Initialization Mode
When any parameter setting is changed in the Initialization Mode, check all parameter
set values in SV Setting Mode and Parameter Setting Mode.
The section in each image of the controller shows the digits which are not high-lighted.
1. Press the <R/S key for two seconds while pressing the SET key from any display in the
Initialization Mode. The controller goes back to the operation mode and the PV/SV display will
be displayed.
2. Press the SET key for two seconds in the PV/SV display.
3. Press the SET key until “LCK” (Set Data Lock display) will be displayed.
4. The high-lighted digit indicates which digit can be set. Press <R/S key to high-light the thousands
digit. (See 4. on P. 1.)
5. Press the DOWN key to change 1 to 0.
6. Press the SET key to store the new set value. The display goes to the next parameter, and the
Initialization mode is locked.
R/S
SET
PV
SV
OUT1 ALM1 ALM2OUT2AT
Set data lock function display
Set value
0 : Initialization mode locked
1 : Initialization mode unlocked
R/S
SET
PV
SV
OUT1 ALM1 ALM2OUT2

AT
CT1 input value displa
y
The parameter displayed varies
on the instrument specification.

RKC INSTRUMENT CB100 Specifications

General

Brand	RKC INSTRUMENT
Model	CB100
Category	Controller
Language	English