RKC INSTRUMENT CB100 - 2. WIRING

1. TRANSFER TO MODE
IMCB04-E10
2
6. Press the SET key to store the new set value. The display goes to the next parameter, and the
Initialization mode is unlocked.
7. Press the <R/S key for two seconds while pressing the SET key to go to the Initialization Mode.
When the controller goes to the Initialization Mode, “Cod” will be displayed.
R/S
SET
PV
SV
OUT1 ALM1 ALM2OUT2

AT
CT1 input value display
R/S
SET
PV
SV
OUT1 ALM1 ALM2 OUT2AT
Initialize code selection
display of initialization mode
R/S
SET
PV
SV
OUT1 ALM1 ALM2OUT2

AT
CT1 input value display
The parameter displayed varies
on the instrument specification.