RMG EC 24 - Programming

OPERATION
...............................................................................................................................................................................................................
...............................................................................................................................................................................................................
Manual EC 24 · EN05 · 2015-02
15
Programming
Via the programming keys
For programming the EC 21 / EC 24, there are four buttons on the rear side of the board. The
official parameters are protected by a calibration switch and a password.
Via the programming module
Instead of using to the programming keys, you can program the device using the programming
module. The programming module is to be connected via a pin connector (see the picture below).
Programming
module
Programming
keys
P
Servicemodul
TERZ94trm
TERZ94p
Impulsausgänge
Datenschnittstelle
Datenschnittstelle
EZD/RS-485
Boot
TP-GND
Impulseingang
X2_0
X4
X15
X9
X151
X5
CX2
CX3
C
X
6
CX1
L1
X6_0
X152
X_S1
XLP1
Reed 1+3 / 2+4
Sensorverstärker 3+4
Wiegand 3+5 / 4+6
4
26
5
31
X_S2
X10-0
TEMP_LM7X
EZSENS01
PT1000
5
31
3
2 1
C21
C1
V12 V13 V14
C22
Q1
X7
X16_0
X1
X3
Taster
RESET
X_TERZ90
S3 S1 S2 S4
P
Programming with the programming module is to be performed in the same way as with the internal
buttons.
P
+
-

