14.
CHECKS
AND
CORRECTIONS
After disassembling and cleaning the engine parts,check them, and if necessary,correct them according to
the
correction table.
The correction table applies whenever engines are repaired. Its contents should be thoroughly understood
by those who undertake the repairing.
Its specifications must be abided by to effect correct maintenance.
Following are the terms
employed
in the
correction
table.
1)
CORRECTION
All
operations performed on the engine
parts
for the purpose
of
improving or recovering the engine
performance, consisting
of
repairs, readjustments, and replacements.
2)
STANDARD
SIZE
The design dimension
of
the part without
the
tolerance.
3)
CORRECTION TOLERANCE
The tolerance on the re-finished part dimension
or
on
the
readjusted dimension.
4)
CORRECTION LIMIT
The
limit
on
the part and adjustment, beyond which
any
dimensional and functional changes, due to
wear,
bum,
and other causes will adversely affect
the
normal engine
performance.
5)
USE
LIMIT
The limit,beyond which the
part
is
no
longer usable,due to defects
in
function or strength.
-
57
-
To Next Page
Loading...
Need help?
General
