13.
CHECKS
and
CORRECTIONS
After disassembling and cleaning the engine, check and repair,
if
necessary, according to the correction table.
The correction table apolies whenever the engines are repaired. It is important for the servicemen to
be
familier with the contents
of
this table. Correct maintenance is recommended by observing the correction
standards specified.
The meanings
of
the terms used in the correction table are as follows:
1)
Correction
2)
Correction Limit
Repair, adjustment or replacement
of
any engine parts.
The limit on wear, damage or functional deterioration
of
engine parts beyond which normal engine per-
formance cannot be expected without repairing such parts.
The
limit beyond which
parts
can
no
longer be used
in
respect
of
performance
or
strength.
The design dimensions
of
new parts minus tolerance.
Tolerance on the dimensions of engine parts refinished or adjusted.
3)
Use Limit
4)
Standard Dimensions
5)
Correction Tolerance
.
.
..
..
-
47
-
To Next Page
Loading...
Need help?
General
