11
Fitting the Doors
78.The strike plate (I.D. Chart No. 70)
which was temporarily fitted earlier can
now be fixed in its final position. Line
up the hole in the plate so that the door
lock engages.
FITTING THE DOORS
79. Slide door wheels into top track, at the
same time ensuring the nylon door
glide engages in the door guide.
Slide on completely and repeat
process for other door.
CONSTRUCTION DETAILS
ASSEMBLING THE DOORS
80. Check that both doors run freely, if not then check that
the outer track is sitting squarely on the inner track. It
may be that the centre door stop (Double doors only)
is fitted incorrectly and is preventing this. Also check
that door track is parallel to door guide.
81.When the doors are running to your satisfaction, fit a
rubber door stop to each end of the track in the holes
provided using M4 X l0mm stainless steel nut, bolt and
washer.
Nylon brush strip
Inner side member + strike Outer side member + lock
1. 2. 3. 4.
Edging strip
Side member
Double door
Nylon brush strip
Door cross bar
Edging strip
Pan head bolt
and nut
Self-tapping
screws (bottom
and top only)
Glass
Single door
Glass
To Next Page
Loading...