26
ASSEMBLY
For Shelving or Staging which needs to be
reduced in length to clear a Robinsons
Partition/Sliding Door it is necessary to
fit the Partition clearance adaptor.
Insure you leave sufficient
clearance for the sliding door.
Check adaptor for being upright
(plumb) and drill 7mm (
1
/4”)
diameter holes in Eaves Rail and
Base rail and secure with square
head bolts.
Position Shelving/Staging brackets
to your required height and drill
the Partition adaptor, 7mm (
1
/4”)
diameter hole, securing with
square head bolts.
Reduce length of Slats to suit.
For 10 Slat Staging only you will
need to drill a 7mm (
1
/4”) diameter
hole for fixing the Rod Cleat and
Support Rod (see main Staging
instructions)
For Right Angle Joining of Slats slide square head
bolts into Slat ‘A’ (one per slat to be joined).
Slide one square head bolt (per Slats ‘B’) and
secure with Slat corner Joining Plate on
underside.
Check space between Slats are correct and that
Slats ‘B’ are hard up to Slat ‘A’ prior to tightening
the bolts.
NOTE:
You may have to reduce the length of Slats ‘B’ to
suit.
Right Angle Corner Plates & Partition Clearance Adaptor Assembly Instructions
Partition Clearance Adaptor Right Angle Corner Plates
Exploded View
Eaves Rail
Partition
Clearance
Adaptor
Staging
Bracket
Shelving
Bracket
Underside View
Cleat
Base Rail
Robinsons Partition
Slat Corner
Joining Plate
Slats ‘B’
Slats ‘A’
To Next Page
Loading...