Robustel GoRugged M1000 User Manual

Robustel GoRugged M1000 User Guide
RT_UG_M1000 Standard_v.2.0.0 20.12.2013 70 / 83
Confidential
When there is a password, SMS command has following structure: Password:cmd1;cmd2;cmd3;…;cmdn
 Cmd1, cmd2, cmd3 to Cmdn, which are command identification number 0000 – 9999
 A, b, c to n, which are command parameters
 The semicolon character (‘;’) is used to separate more than one commands packed in a single SMS.
5.3.2 SMS Control Steps
1. Use command Password:cmd1;cmd2;cmd3;…;cmdn or cmd1;cmd2;cmd3;…;cmdn to set new parameters.
2. After setting new parameters for M1000, remember to use 0004 command to save parameters and reset the
modem, then the new parameters will take effect.
3. In one SMS, if there is more than two cmd, remember to use punctuation “;” to divide each cmd.
Note: E.g., 1234:1001,M1000;0004
In this command, password is 1234, 1001 is the cmd to set device’s name, “M1000” is M1000’s name that we want to
set, then save parameters and reset the modem to take effect with command 0004.
5.3.3 SMS Commands List
Cmd
Description
Syntax
Comments
Control Commands
0000
Set Factory Defaults
password:cmd or cmd
if no password, please use command
"cmd", or use command "password:cmd" if
there is a password.
Following commands are the same.
0001
Reset Device
cmd
0002
Save Parameters
cmd
0003
Get Device Status
cmd
0004
Save Parameters and
Reset Device
cmd
0005
Clear SMS Count
cmd
0006
Clear Event Count
cmd
0007
Start Event Counter
cmd
Set Commands
1000
Set Comm Parameters
cmd,baud rate,parity,data bits,stop
bits,flag
baud rate: 1200 - 115200
parity: n,o,e,m,s
data bits: 7,8
stop bits: 1,2
*flag:
0 - RS232
1 - RS485
1001
Set Device Name
cmd,name
name(max 20 bytes)
1002
Set SIM Card Pin
cmd,flag1,pin,flag2,newPin
flag1:

Robustel GoRugged M1000 Specifications

General

Brand	Robustel
Model	GoRugged M1000
Category	Modem
Language	English