30
Meter Settings
5
Press to highlight On.
Press
to move to
the option. Press
.
This message appears
if Target Ranges is O:
Press
to highlight
Yes. Press
.
(To turn Patterns O,
select No. Press
to return to Patterns.)
Target Ranges appears
on the display (see the
Target Ranges section of
this chapter for details on
setting target ranges).
If Patterns is On and a new pattern is
detected with a blood glucose result, a
message appears on the display.
or
Press to select Details to view the
blood glucose results that make up that
pattern.
Press
to highlight View later.
Press to return to the previous screen.
Reminders
You can set up to 4 general test Reminders
per day to remind you to test. A series of
beeps sound and
is displayed for
Reminders set in the meter.
Reminders:
• turn o by inserting a test strip or pressing
any button.
• are postponed until the next test reminder
if a test was performed within 15 minutes
of a test reminder.
• do not appear/beep if the meter is on at
the test reminder time (including when the
meter is connected to a USB cable).
• do not appear/beep if the meter is
connected and communicating to a
Continua Certified
®
manager.
• do not beep if the meter beeper is set to
o.
• do not appear/beep if the batteries need to
be replaced.
Set Reminders
• Reminder times are pre-set in the meter
for 8:00 am, 12:00 pm, 6:00 pm, and
10:00 pm. You may change reminder times
by following the instructions below.
• If a general test Reminder is set for the
same time as a Post Meal reminder, the
Post Meal reminder will appear/beep
instead of the general Reminder (see the
Post Meal Reminders section of this
chapter for details).
Turn the meter on by
briefly pressing
. From
Main Menu, press
to
highlight Settings. Press
.
2
Press to highlight
More Options. Press
.
82052_08100918004.indd 30 6/9/2020 12:07:28 PM
To Next Page
Loading...
