102 Rockwell Automation Publication 1766-UM001O-EN-P - September 2021
Chapter 5 LCD and Keypad
Note: For firmware revisions 21.000 or later the LCD password screen
displays.
5. Enter the master password, then press OK on the LCD keypad.
Note: For firmware revisions 21.000 or later, press OK on the LCD
password screen.
6. If the master password is incorrect, an error message displays.
7. If the password is correct, the Ethernet network type screen displays as
shown. Press Up or Down key to select the appropriate Ethernet mode.
8. If you press OK at the static mode, the IP address flashes.
To Next Page
Loading...
Need help?
General
