CompactLogix Packaged Controllers 11
Publication 1769-IN082A-EN-P - July 2008
Connect Expansion Modules (optional)
If using expansion modules with your packaged controller, complete these steps to
attach the modules.
1. Remove the end cap by unlocking it and sliding it forward.
2. Align the tongue-and-groove slots of the expansion module with those on
the right end of the packaged controller.
3. Slide the module onto the packaged controller.
4. Close the locking tab on the top of the module.
5. If using another expansion module, complete steps 2…4 for the second
module.
To Next Page
Loading...
