10 CompactLogix Packaged Controllers
Publication 1769-IN082A-EN-P - July 2008
Install the Battery
Complete these steps to install the battery on your packaged controller.
1. Open the battery door on the left side of the packaged controller.
2. Carefully attach the battery connector to the port located inside the
packaged controller.
3. Insert the battery, wires down, in the slot on the battery door.
4. Close the battery door.
WARNING
When you connect or disconnect the battery an electrical arc can occur. This could cause
an explosion in hazardous location installations. Be sure that the area is nonhazardous
before proceeding.
For Safety information on the handling of lithium batteries, including handling and
disposal of leaking batteries, see Guidelines for Handling Lithium Batteries, publication
AG 5-4
.
To Next Page
Loading...
