Rockwell Automation Publication 2080-UM002N-EN-E - November 2022 277
Appendix B Quickstarts
2. Click Connect to connect to the target controller.
On the Device Details toolbar, the Secure tooltip message “Set, Change, or Clear
Micro800 Controller Password Protection” is displayed.
3. Click Secure. Select Set Password.
4. The Set Controller Password dialog appears. Provide password. Confirm the password
by providing it again in the Confirm field.
5. Click OK.
Once a password is created, any new sessions that try to connect to the controller will
have to supply the password to gain exclusive access to the target controller.
Change Password
With an authorized session, you can change the password on a target controller through the
Connected Components Workbench software. The target controller must be in Connected
status.
Passwords must have at least eight characters to be valid.
To Next Page
Loading...
Need help?
General
