294 Rockwell Automation Publication 2080-UM002N-EN-E - November 2022
Appendix B Quickstarts
6. The controller will automatically go into Debug mode and display the updated project.
7. You can now choose to either Undo or Accept the changes to the project.
To Undo the Changes
1. Click the Undo Changes icon.
2. The changes will be discarded and the original project will be restored to the controller.
Observe that original project is shown and the controller is in Debug mode.
To Accept the Changes
1. Click the Accept Changes icon.
2. Observe that only the Run Mode Change icon is now enabled and the controller remains
in Debug mode.
IMPORTANT When a Test Logic is performed, or undoing changes after the
Test Logic is completed, any active communication instructions
will be aborted while the changes are downloaded to the
controller.
To Next Page
Loading...
Need help?
General
