Publication 2711P-UM001D-EN-P - September 2005
Troubleshooting 8-13
System Identification Errors
The error messages in this section appear on startup if incorrect or
invalid components are used with the 700-1500 terminals.
• This dialog appears if a VersaView CE logic module is attached
to a PanelView display module or a PanelView Plus logic
module is attached to a VersaView CE display module. It is
recommended that you use a VersaView CE display module with
a VersaView CE logic module and a PanelView Plus display
module with a PanelView Plus logic module. This is a warning
allowing you to continue to operate.
• This dialog appears if the PanelView Plus logic module contains
a 6189-RWx internal compact flash card for the VersaView CE
terminal.
After pressing OK, you will be asked to power off the terminal
and insert a valid 2711P-RWx internal compact flash card for the
PanelView Plus terminal.
• This dialog appears if the VersaView CE logic module contains a
2711P-RWx internal compact flash card for the PanelView Plus
terminal.
.
After pressing OK, you will be asked to power off the terminal
and insert a valid 6189-RWx internal compact flash card for the
VersaView CE terminal.
700-1500 only
(6189-RWX)