Rockwell Automation Allen-Bradley SMC-Flex 150

Bulletin 150 SMC-Flex™
iiiiii
Chapter 4
Programming
Overview ....................................................................................... 4-1
Keypad Description ........................................................................ 4-1
Programming Menu ....................................................................... 4-1
Password ...................................................................................... 4-5
Parameter Management ................................................................ 4-6
Random Access Memory (RAM) .............................................. 4-6
Read-only Memory (ROM) ....................................................... 4-6
Electrically Erasable Programmable Read-only Memory
(EEPROM) ............................................................................... 4-6
Using Parameter Management with DPI HIM ........................... 4-7
Parameter Modification ................................................................. 4-8
Soft Start ....................................................................................... 4-9
Current Limit Start ......................................................................... 4-9
Dual Ramp Start .......................................................................... 4-10
Full Voltage Start ......................................................................... 4-11
Linear Speed ............................................................................... 4-11
Programming Parameters ............................................................ 4-12
Basic Set Up ................................................................................ 4-15
Motor Protection .......................................................................... 4-16
Example Settings ......................................................................... 4-17
Undervoltage ......................................................................... 4-17
Overvoltage ........................................................................... 4-17
Jam....................................................................................... 4-17
Underload.............................................................................. 4-17
Chapter 5
Motor Information
Overview ....................................................................................... 5-1
Motor Data Entry ........................................................................... 5-1
Chapter 6
Metering
Overview ....................................................................................... 6-1
Viewing Metering Data .................................................................. 6-1
Chapter 7
Optional HIM Operation
Overview ....................................................................................... 7-1
Human Interface Module ............................................................... 7-1