ca.
How
To Set
The
Tutti /
PL
1 /
PL2
Toe Piston Combinations:
1.
Press and
hold
down the
Rand
1 piston.
2.
While holding these pistons, press the 0 (General Cancel) piston.
3. Press the Tutti,
PLI
or PL2 piston; the current relative stop configuration lights.
4. Set the
new
desired stop configuration.
5. While
holding
the SET piston, press the Tutti,
PLI
or PL2 piston, and then release both
pistons simultaneously.
TUNING
CONTROL
The 525 and 535 organs are equipped with a TUNING control. This allows the entire organ to be
tuned easily and quickly to a piano or musical instmment not at standard concert pitch (A=440).
If
the TUNING control is pushed in, the organ will remain at standard concert pitch, and turning the
control will have
no
effect.
To
alter the pitch, press the TUNING control until it moves outward and
clicks, then tum
the
control to set the pitch.
TRANSPOSER CONTROL
Turning the
TRANSPOSER
control will raise or lower the pitch of the organ up to four semitones
(half steps) flat,
and
up to three semitones sharp. Many singers need a key change to accommodate
their voice range.
The
TRANSPOSER is especially useful for accompanying soloists, eliminating
the need to mentally transpose printed music into a more suitable
key.
The TRANSPOSER helps
the organist accomplish this effortlessly.
MASTER
VOLUME
CONTROL
This knob controls the overall volume
of
the entire instmment. Set
it
near its midpoint to obtain the
best performance.
REVERB
LEVEL
This control adjusts the total amount
of
digital reverberation affecting the organ voices.
6
To Next Page
Loading...
