ENABLING/DISABLING MIDI MASTER CHANNELS
The following MIDI channels are used to control the organ through MIDI:
Great Master Channel 12
Swell Master Channel
13
Pedal Master Channel 14
It
is
possible to stop the transmission or reception
of
MIDI information on these Master
Channels.
To
disable reception
of
information on a MIDI Master Channel:
1.
Hold SET and press the bottom
of
the MIDI coupler corresponding to the channel to be
disabled. It will flash. Release SET and the MIDI coupler.
2.
While the coupler
is
flashing, press the top
of
the MIDI coupler (as
if
turning off).
It
will
stop flashing.
To
enable reception
of
information on a MIDI Master Channel:
1.
Hold SET and press the bottom
of
the MIDI coupler corresponding
to
the channel
to
be
enabled. It will flash. Release SET and the MIDI coupler.
2.
While the coupler
is
flashing, press the bottom
of
the MIDI coupler (as
if
turning on).
It
will stop flashing.
When transmission on all MIDI Master Channels is inhibited, then no stop change (MIDI System
Exclusive stop change)
is
transmitted.
To
disable transmission
of
information on a MIDI Master Channel:
1.
Hold SET and press the MIDI coupler corresponding to the MIDI Master Channel
to
disable. It will flash. Release the MIDI coupler.
2.
While the coupler
is
flashing, hold SET and press the top
of
the MIDI coupler (as if
turning off). It will stop flashing.
To
enable transmission
of
infOlmation on a MIDI Master Channel:
1.
Hold SET and press the bottom
of
the MIDI coupler corresponding
to
the MIDI Master
Channel to enable.
It
will flash. Release the MIDI coupler.
2.
While the coupler
is
flashing, hold SET and press the bottom
of
the MIDI coupler (as
if
turning on).
It
will stop flashing.
Note: The send and receive status
of
all MIDI Master Channels are not saved in the
combination action
of
the 525/535 models.
14
To Next Page
Loading...
