EXPRESSION PEDAL
The pedal
on
the left controls the overall volume
of
the Swell Division or the total volume of the
instrument (see settings on Page 20, to switch change the Expression Pedal Mode). This pedal
is
used
to
give variety
of
expression to the music played. Pressing the pedal forward increases the
volume; drawing back decreases the volume.
KICK SWITCH FOR MIDI SUSTAIN
A SideKick switch is located
to
the left side
of
the EXPRESSION Pedal. When actvated, it sends
MIDI sustain (Hold) messages to the GREAT MIDI coupler channel.
CRESCENDO PEDAL (Only 535)
The pedal to the right
of
the Expression Pedal
is
the CRESCENDO Pedal, which gradually adds a
user pre-determined selection
of
stops
as
it
is
pressed forward. The CRESCENDO Pedal does not
affect the stops already set up on the organ, but merely adds to them. Stops added by the CRE-
SCENDO Pedal do not light.
When the CRESCENDO Pedal is in use, the Crescendo indicators will light (from left to right)
as
the pedal is depressed and more stops are added. A change in the setting
of
the crescendo differing
from the sequence set at the factory may be desired.
e&.
How
To
Set
The
Crescendo:
1.
While holding piston R and piston
1,
press the °(General Cancel) piston.
2.
Move
the CRESCENDO Pedal; the stops contained in the
CUlTent
step number will light.
Set the desired stop configuration for the
CUlTent
step number.
3.
Press the SET button and the stop configuration
is
stored as the
CUlTent
step number.
4. Repeat steps
1-3
to
set the remaining Crescendo step numbers.
TUTTI /
Pl1
/
Pl2
(Only 535)
There are times when different full organ registrations are needed immediately. The 535 model
is
equipped with a Tutti,
PL1
and PL2 toe pistons. Press the toe piston
to
tum on the Tutti,
PL1
or
PL2, and press again
to
tum it off.
When "TUTTI"
is
"ON", the TUTTI indicator lights.
When
"PL1"
is
"ON", the TUTTI indicator blinks at low frequency
When "PL2
is
"ON", the TUTTI indicator blinks at a higher rate
When
"PL1"
and "PL2" are both "ON" the TUTTI indicator blinks very fast.
When these preset combinations are activated, the selected tilt tabs do not light. These "Factory"
combinations can be user adjusted.
5
To Next Page
Loading...
