CHANNEL
REASSIGNMENT
All MIDI couplers transmit on fixed channels except MIDI ON
GREAT.
To
set the transmit
channel for this coupler:
1.
Hold SET and press the bottom of MIDI ON
GT.
It will flash. Release SET and MIDI
ONGT.
2.
Hold piston
1,
and press any key on the Great manual between low C and tenor D#
to
signify the desired MIDI channel. Low C
is
Channell,
low C#
is
Channel
2,
etc. The
MIDI ON GT coupler will stop flashing.
Note: The new Great MIDI Channel assignment will be stored in the combination action
of
the organ.
OCTAVE TRANSPOSE
Normally, all MIDI couplers play at standard pitch (middle C =MIDI note 60). The Octave
Transpose parameter may be reset to cause any MIDI coupler to play one octave above or below
standard pitch.
1.
Hold SET and press the bottom
of
the desired MIDI coupler.
It
will flash. Release SET
and the MIDI coupler.
2.
To
transpose up one octave, turn the TRANSPOSER control
to
+1, +2,
+3
or
+4.
3.
To
transpose down one octave, turn the TRANSPOSER control to -1, -2,
-3
or
-4.
4. Exit this mode by pressing 0 (General Cancel).
5. Return the TRANSPOSER to the desired setting.
Note: The Octave Transpose status
of
each MIDI coupler will be stored in the combination
action of the organ.
To
return a MIDI coupler to standard pitch repeat steps 1-5 and return the TRANSPOSER from
+1 to 0 if returning from one octave sharp. Return the TRANSPOSER from
-1
to 0 if returning
from one octave flat.
13
To Next Page
Loading...
