Roger Technology CTRL - Page 38

EN
76
• If the motor calibration procedure is successful, the message 3+$ƽEWLIWSRXLIHMWTPE]
• To lock the barrier again
AGILIK-KB-BIONIK4HP-BIONIK6-BIONIK8. Turn the key clockwise by two full turns.
BIONIK4. Close the release cover and turn the key.
• The acquisition procedure now starts. The message $XWR is shown on the display and the barrier starts opening
at low speed.
• 3RGIXLIFEVVMIVSTIRQIGLERMGEPWXSTMWVIEGLIHXLIFEVVMIVWXSTWFVMIƽ]8LIQIWWEKI$XWRƽEWLIWSRXLIHMWTPE]
• The barrier closes until it reaches the barrier closed mechanical stop.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display mode.
-JXLIJSPPS[MRKIVVSVQIWWEKIWEVIWLS[RSRXLIHMWTPE]VITIEXXLIEGUYMWMXMSRTVSGIHYVI
• QR3+GEPMFVEXMSRTVSGIHYVIJEMPIH
• $33.(EGUYMWMXMSRIVVSV
For more information, see chapter 16 “Alarms and faults”.
The correct self-learning procedure of the barrier in STANDARD and MASTER/SLAVE mode requires that
XLIƼVWXSTIVEXMSRSJXLIFEVVMIVMWEP[E]WJVSQqXS[EVHWSTIRMRK-RGEWIXLIƼVWXSTIVEXMSRMWJVSQq
towards closing, check again the correct position of the barrier opening and then set again the value of
parameter .
For connection and wiring operation consider:
• Wiring mains power cable to the MASTER barrier
• RS485 bus connection wiring: check the correspondence of the cables that must connect the LNA
MASTER terminal with the LNA SLAVE terminal, similarly for the LNB MASTER and SLAVE terminals
• Always check that the ST (STOP) and COM inputs are jumpered (if no STOP button is installed, N.C. contact)
• the parameters concerning the functionality of the central unit are managed exclusively by the MASTER central
unit which automatically passes them to the SLAVE central unit. Only parameters $,,  and  must be set on
the SLAVE control unit