Roger Technology CTRL - Page 37

EN
75
If the installation position is changed from the right to the left, the position of the spring(s) must also be
changed.
6. MASTER EGUYMWMXMSRTVSGIHYVI
AP P- PH A5
AU to
PROG
x4 s
OPENING OPEN
CLOSING
CLOSED
Yes
UNLOCK
LOCK
2x360°
2x360°
PH A5
AU to
45°
ONLY FOR BI/004
wait...
wait...
ONLY FOR BI/004
BIONIK 4HP, 6,
8, PC, PE
BIONIK 4HP, 6,
8, PC, PE
• Press and hold PROG for 4 seconds. $33 is shown on the display.
• Unlock the barrier.
AGILIK-KB-BIONIK4HP-BIONIK6-BIONIK8. Turn the key anticlockwise by two full turns.
BIONIK4. Open the release cover.
• The barrier goes to 45° degree.
• After a few seconds, the message 3+$6 is shown on the display. The controller unit launches a calibration procedure.
The operating parameters of the motor are determined during calibration.
• If the motor calibration procedure is successful, the message 3+$ƽEWLIWSRXLIHMWTPE]
• To lock the barrier again
AGILIK-KB-BIONIK4HP-BIONIK6-BIONIK8. Turn the key clockwise by two full turns.
BIONIK4. Close the release cover and turn the key.
• The acquisition procedure now starts. The message $XWR is shown on the display and the barrier starts opening
at low speed.
• 3RGIXLIFEVVMIVSTIRQIGLERMGEPWXSTMWVIEGLIHXLIFEVVMIVWXSTWFVMIƽ]8LIQIWWEKI$XWRƽEWLIWSRXLIHMWTPE]
• The barrier closes until it reaches the barrier closed mechanical stop.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display mode.
-JXLIJSPPS[MRKIVVSVQIWWEKIWEVIWLS[RSRXLIHMWTPE]VITIEXXLIEGUYMWMXMSRTVSGIHYVI
• QR3+GEPMFVEXMSRTVSGIHYVIJEMPIH
• $33.(EGUYMWMXMSRIVVSV
For more information, see chapter 16 “Alarms and faults”.
7. SLAVE EGUYMWMXMSRTVSGIHYVI
AP P- PH A5
AU to
PROG
x4 s
OPENING OPEN
CLOSING
CLOSED
Yes
UNLOCK
LOCK
2x360°
2x360°
PH A5
AU to
45°
ONLY FOR BI/004
wait...
wait...
ONLY FOR BI/004
BIONIK 4HP, 6,
8, PC, PE
BIONIK 4HP, 6,
8, PC, PE
• Press and hold PROG for 4 seconds. $33 is shown on the display.
• Unlock the barrier.
AGILIK-KB-BIONIK4HP-BIONIK6-BIONIK8. Turn the key anticlockwise by two full turns.
BIONIK4. Open the release cover.
• The barrier goes to 45° degree.
• After a few seconds, the message 3+$6 is shown on the display. The controller unit launches a calibration procedure.
The operating parameters of the motor are determined during calibration.