Roger Technology H70/105AC - Page 57

EN
57
11.2 SELF-ACQUISITION PROCEDURE WITH LIMIT SWITCHES,
WITHOUT ENCODER (R30/1209 - G30/2205 SERIES)
WARNING: &IJSVIWXEVXMRKXLIWIPJEGUYMWMXMSRTVSGIHYVIWIXTEVEQIXIVW - Deceleration space setting.
PROG
TEST
AP P- AP 1
CH 1
x4 s
OPENING
OPEN
CLOSING
CLOSE
TEST
TEST
00
18
Yes
No
Yes
PROG
1 click
PA
x2 s
See safety input (Chap. 14) and
Alarm and fault (Chap. 15)
• /IITE[E]JVSQXLITLSXSGIPPFIEQXSTVIZIRXMRXIVVYTXMRKXLITVSGIHYVI
• Press and hold PROG for 4 seconds. $3 3 is shown on the display.
• Press PROG again.
• The gate starts an opening manoeuvre at the speed selected in par. . $3is shown on the display.
• 3RGIXLIVIPEXMZIPMQMXW[MXGLMWEGXMZEXIHXLIKEXIWXSTWFVMIƽ]
• SDƽEWLIWSRXLIHMWTPE]JSVWIGSRHW
• %JXIVXLMWWIGSRHMRXIVZEPKEXIGPSWIWEYXSQEXMGEPP]8LIQIWWEKI&+ appears on the display.
• The self-acquisition procedure concludes when gate reaches the closed limit switch.
• -JXLIEGUYMWMXMSRTVSGIHYVIMWGSQTPIXIHWYGGIWWJYPP]XLIHMWTPE]IRXIVWXLIGSQQERHERHWEJIX]HIZMGIWXEXI
display mode.
-JXLIJSPPS[MRKIVVSVQIWWEKIWEVIWLS[RSRXLIHMWTPE]VITIEXXLIEGUYMWMXMSRTVSGIHYVI
• $33(acquisition error4VIWWXLI8)78FYXXSRXSGPIEVXLIIVVSVERHGLIGOXLIWEJIX]HIZMGIMREPEVQWXEXI
LFor more information, see chapter 16 “Alarms and faults”.
B