Roger Technology H70/105AC - Function Buttons and Display; Switching on or Commissioning

EN
53
CONTACT DESCRIPTION
H70/105AC
29 34 35
COM
30 3231
FC2
24V
FC1
33
-RTYXW2'JSVGSRRIGXMRKGPSWIHERHSTIRPMQMXW[MXGLIWƼK
Use a 4x0.5 mm
2
cable to connect the limit switch to the control unit.
The gate stops when the limit switch is activated.
The terminal 24 V AC input may only be used to power ROGER TECHNOLOGY magnetic limit
switches.
The ROGER TECHNOLOGY magnetic limit switch is equipped with a plug-in connector. If used with
the H70/105ACGSRXVSPYRMXGYXSJJXLIGSRRIGXSVERHGSRRIGXXLI[MVIWEWWLS[RMRƼK
N.B.:MJXLIPMQMXW[MXGLIWEVIRSXMRWXEPPIHSVRSXYWIH DO NOT jumper contacts FC1-COM e FC2-
COM, but disable them by par. 72.
The limit switch function depends on the setting for parameter .

FC1 = Opening limit switch FC2 = Closing limit switch

FC1 = Closing limit switch FC2 = Opening limit switch
29
+5V
34
ENC
35
COM
-RTYXJSVGSRRIGXMRK63+)68)',2303+=)2'3()6ƼK
The optical encoder is enabled by default ( ).
WARNING! Always disconnect from electrical power before disconnecting or connecting the
encoder cable.
RECEIVER CARD
Connector for plug-in radio receiver board.
8LIGSRXVSPYRMXLEWX[SVEHMSVIQSXIGSRXVSPJYRGXMSRWF]HIJEYPX
– 46WXITQSHIGSQQERHQSHMƼEFPI[MXLTEVEQIXIV
– 46TEVXMEPSTIRMRKGSQQERHQSHMƼEFPI[MXLTEVEQIXIV
8 Function buttons and display
PROG
UP
DOWN
TEST
BUTTON DESCRIPTION
UP
a
Next parameter
DOWN b
Previous parameter
+ Increase value of parameter by 1
- Decrease value of parameter by 1
PROG Programme travel
TEST Activate TEST mode
• Press the UP c and/or DOWN b buttons to view the parameter you intend to modify.
• 9WIXLIERHFYXXSRWXSQSHMJ]XLIZEPYISJXLITEVEQIXIV8LIZEPYIWXEVXWXSƽEWL
• Press and hold the + or -FYXXSRXSWGVSPPUYMGOP]XLVSYKLZEPYIWXSQSHMJ]XLITEVEQIXIVQSVIUYMGOP]
• 8SWEZIXLIRI[ZEPYI[EMXEJI[WIGSRHWSVQSZISRXSERSXLIVTEVEQIXIV[MXLXLI94a or DOWN b button. The
HMWTPE]ƽEWLIWVETMHP]XSMRHMGEXIXLEXXLIRI[ZEPYILEWFIIRWEZIH
• 4EVEQIXIVWGERSRP]FIQSHMƼIH[LMPIXLIQSXSVMWRSXVYRRMRK4EVEQIXIVWGERFIZMI[IHEXER]XMQI
9 Switching on or commissioning
Power the control unit.
8LIƼVQ[EVIZIVWMSRSJXLIGSRXVSPYRMXMWHMWTPE]IHFVMIƽ] See chapter 7.