EN
59
12 Index of parameters
PARA M.
FACTORY
DEFAULT
DESCRIPTION PAGE
$
Automatic close after pause time (from gate completely open) 61
$
Automatic gate closing after mains power outage (black-out) 61
$
Selecting step mode control function (PP) 61
$
4VIƽEWLMRK 61
$
Condominium function for partial open command (PED) 61
$
Enabling operator present function. 61
$
Gate open indicator / photocell test function 62
Set deceleration space (%) 62
Gate fully open/closed position control setting 62
Partial opening adjustment (%) 62
7IXXMRKEHHMXMSREPXMQIEJXIVHMVIGXMSRMRZIVWMSR[MXLRSIRGSHIV 62
Setting automatic closing time 62
Setting motor manoeuvre time 62
Enable double manoeuvre time 62
Setting reverse time after activation of sensing edge or obstacle detection
(crush prevention).
63
Setting electric lock activation lead time 63
Setting electric lock activation time 63
)REFPIERXMHMWXYVFERGIƼPXIVJSVTS[IVJVSQKIRIVEXSV 63
Set motor torque during manoeuvre 63
Set motor torque during deceleration 63
Adjusting of motor torque 63
Set initial acceleration when opening/closing (soft-start) 63
Set torque after activation of sensing edge or obstacle detection system 63
Set initial maximum torque boost time 63
Set open/closed stop approach distance 63
Enable lock release reverse impulse 64
Set deceleration during opening/closure 64
Set obstacle detection sensitivity during manoeuvres 64
Set obstacle detection sensitivity during deceleration 64
Number of automatic closure attempts after activation of sensing edge or
obstacle detection (crush protection)
64
Setting photocell mode during gate opening (FT1) 64
Setting photocell mode during gate closing (FT1) 64
Photocell (FT1) mode with gate closed 65
Setting photocell mode during gate opening (FT2) 65
Setting photocell mode during gate closing (FT2) 65
Photocell (FT2) mode with gate closed 65
Enable close command 6 s after activation of photocell (FT1-FT2) 65
To Next Page
Loading...
