[20] – Delete all users
Reader deletes all users (cards and PIN-s) so that all user IDs are released and can be
programmed anew. The MASTER and INSTALLER users are not deleted with this function.
[21][PIN][#] – Delete a PIN
The reader searches its memory for the entered PIN. Once successful it removes the PIN from its
memory and the record previously occupied by this PIN is released. This command removes only
PIN, if the user has card then it still can be used.
[22][Card] – Delete a card
The reader searches its memory for the presented card. Once successful it removes it from the
memory and the record previously occupied by this card is released. This command removes only
card, if the user has PIN then it still can be used.
[23][ID] – Delete a user with given ID
A user with entered ID is deleted (both his card and his PIN are removed), a new user can be
programmed to use this ID index.
[24][YYMMDDhhmm] – Setting date and time
Where: YY – two last digits of year (00-99), MM – month (01-12), DD – day (01-31), hh – hour
(00-23), mm – minute (00-59)
[#] – Exit from User Programming Mode
After exiting from the User Programming mode reader returns to either armed or disarmed mode
depending on which one was set prior to User Programming Mode.
Programming Examples
Example 1: Add a new TOGGLE LTD user with a card; programming sequence: [1][8][Card][#] or
[1][8][Card][Wait ~10s or press [#]]
Read your MASTER card or enter MASTER PIN
The reader enters User Programming mode (LED OPEN is on and LED STATUS is
on and red)
Press [1][8]
LED SYSTEM starts flashing
Present a card which you want assign for a new TOGGLE LTD user
Press [#], command is completed
The reader has completed programming function, however, it has not left User Programming mode
so now you can enter another programming command.
Example 2: Delete a user with ID=45; programming sequence: [2][3][0][4][5]
Read your MASTER card or enter MASTER PIN if you are not in User Programming mode
The reader enters User Programming mode (LED OPEN is on and its LED STATUS
is on and red)
Press [2][3]
LED SYSTEM starts flashing
Press [0]
Press [4]
Press [5]
Press [#], command is completed
The user with ID=45 has been deleted, reader still remains in User Programming mode, so now
you can enter another programming command.
To Next Page
Loading...
