9.1.1. User Programming Commands
Note: Any attempt to program an already registered card or PIN will be indicated as a
programming error.
[11][PIN][#] – Add NORMAL user with PIN
The new NORMAL user added with this function is stored in unoccupied (free) location of the
memory i.e. with unknown ID.
[12][Card 1][Card 2]...[Card N][#] – Add multiple NORMAL users with cards
The reader indicates each successful card reading with an acoustic prompt signal (two beep-s) for
the next one to follow. This function is ended automatically if no card is presented within 10 sec
from the previous card reading or you can end it earlier by pressing the [#] key. The new users
added with this function are stored in unoccupied (free) location of the memory i.e. with unknown
IDs.
[13][ID][PIN][#][Card] – Add NORMAL user with ID, PIN and card
The new NORMAL user is registered in the memory at the location indicated by his ID number
(ID=000–119). Both, the entered PIN code and presented proximity card are assigned to
programmed user. When you want to program only PIN enter: [13][ID][PIN][#][#], when you
want to program only card enter: [13][ID][#][Card].
[14][PIN][#] – Add TOGGLE user with PIN
The new TOGGLE user added with this function is stored in unoccupied (free) location of the
memory i.e. with unknown ID.
[15][Card 1][Card 2]...[Card N][#] – Add multiple TOGGLE users with cards
The reader indicates each successful reading of the presented card with an acoustic prompt for the
next one to follow. This function will be ended automatically if no card is presented within 10 sec
from the previous card reading or you can end it manually by pressing [#]. Note, that the new card
users added with this function are stored in unoccupied (free) locations of the memory i.e. with
unknown IDs.
[16][ID][PIN][#][Card] – Add TOGGLE user with ID, PIN and card
The new TOGGLE user is registered in the memory at the location indicated by the ID number (ID
= 000–119). Both, the entered PIN and card are assigned to the user. When you want to program
only PIN enter: [16][ID][PIN][#][#], when you want to program only card enter: [16][ID][Card].
[17][PIN][#] – Add TOGGLE LTD user with PIN
The new TOGGLE LTD user is stored in a first unoccupied memory location with entered PIN i.e.
with unknown ID.
[18][Card 1][Card 2]...[Card N][#] – Add multiple TOGGLE LTD users with cards
The reader indicates each successful reading of the presented card with an acoustic prompt for the
next one to follow. This function will be ended automatically if no card is presented within 10 sec
from the previous card reading or you can end it manually by pressing [#]. Note, that the new
users added with this function are stored in unoccupied (free) locations of the memory i.e. with
unknown IDs.
[19][ID][PIN][#][Card] – Add TOGGLE LTD user with ID, PIN and card
The new TOGGLE LTD user is registered in the memory at the location indicated by ID number
(ID=000–119). Both, the entered PIN and the presented proximity card are assigned to the user.
When you want to program only PIN enter: [19][ID][PIN][#][#], when you want to program only
card enter: [19][ID][Card].
To Next Page
Loading...
