Preparing for Use
R&S
®
FSVA3000/R&S
®
FSV3000
17Getting Started 1330.8073.02 ─ 03
4.1.4 Connecting the AC Power
In the standard version, the R&S FSV/A is equipped with an AC power supply
connector. The R&S FSV/A can be used with different AC power voltages and
adapts itself automatically to it. Refer to the datasheet for the requirements of
voltage and frequency. The AC power connector is located on the rear panel of
the instrument.
For details on the connector, refer to Chapter 5.2.1, "AC Power Supply Connec-
tion and Main Power Switch", on page 51.
► Connect the R&S FSV/A to the AC power supply using the supplied power
cable.
Since the instrument complies with the specifications for safety class
EN61010, only connect it to an outlet that has a ground contact.
4.1.5 Switching the Instrument On and Off
Switching on the instrument
► Press the AC power switch on the rear panel to position "I".
The instrument is supplied with AC power. After booting, the instrument is
ready for operation. The [POWER] key lights up green.
If the [POWER] key lights up orange, the instrument is in standby mode.
Switching off the instrument
1. Press the [POWER] key on the front panel.
The R&S FSV/A switches to standby mode.
2. Set the AC power switch on the rear panel to position "O", or disconnect the
instrument from the AC power supply.
The R&S FSV/A changes into off mode.
Putting into Operation
To Next Page
Loading...
