Preparing for Use
R&S
®
FSVA3000/R&S
®
FSV3000
27Getting Started 1330.8073.02 ─ 03
4.4 Connecting an External Monitor
You can connect an external monitor (or projector) to the "DVI" or "display port"
connector on the rear panel of the R&S FSV/A (see also Chapter 5.2.2, "Display
Port and DVI", on page 51).
Screen resolution and format
The touchscreen of the R&S FSV/A is calibrated for a 16:10 format. If you
connect a monitor or projector using a different format (e.g. 4:3), the calibra-
tion is not correct and the screen does not react to your touch actions prop-
erly.
The touchscreen has a screen resolution of 1280x800 pixels. Most external
monitors have a higher screen resolution. If the screen resolution of the
monitor is set higher than the instrument's resolution, the application win-
dow uses an area of 1280x800 pixels on the monitor display. For full screen
display, adjust the monitor's screen resolution.
The R&S FSV/A supports a minimum resolution of 1280x768 pixels.
1. Connect the external monitor to the R&S FSV/A.
2. Press the [SETUP] key.
3. Press the "Display" softkey.
4. Select the "Configure Monitor" tab in the "Display" dialog box.
The standard Windows "Screen Resolution" dialog box is displayed.
Connecting an External Monitor
To Next Page
Loading...
