Rohde & Schwarz FSVA3000 - Displaying a Marker Peak List

Trying Out the Instrument
R&S
®
FSVA3000/R&S
®
FSV3000
68Getting Started 1330.8073.02 ─ 03
6.6 Displaying a Marker Peak List
The marker peak list determines the frequencies and levels of peaks in the spec-
trum automatically. We will display a marker peak list for the Spectrum 2 channel.
1. Tap the "Spectrum 2" tab.
2. Press the "RUN SINGLE" key on the front panel to perform a single sweep for
which we will determine the peaks.
3.
Tap the "SmartGrid" icon in the toolbar to activate SmartGrid mode.
4. Drag the "Marker Peak List" icon from the evaluation bar to the lower half of
the display to add a new window for the peak list.
5. Close the SmartGrid mode.
6. To obtain a more conclusive peak list that does not contain noise peaks, for
example, define a threshold that is higher than the noise floor:
a) Press the [MKR] key on the front panel.
Displaying a Marker Peak List