Rohde & Schwarz FSVA3000 - Configuring the Initial Instrument Settings; Protecting Data Using the Secure User Mode

Preparing for Use
R&S
®
FSVA3000/R&S
®
FSV3000
35Getting Started 1330.8073.02 ─ 03
4.6 Configuring the Initial Instrument Settings
This section describes how to set up the R&S FSV/A initially. For further basic
instrument settings, see the R&S FSV/A User Manual.
● Setting the Date and Time...............................................................................35
4.6.1 Setting the Date and Time
Assuming you have administrator rights, you can set the date and time for the
internal real time clock as follows:
Opening the Date and Time Properties dialog box
1. Press the [SETUP] key.
2. Press the "Display" softkey.
3. Select the "General" tab in the "Display" dialog box.
4. Press the "Set Date and Time" button to open the standard Windows "Date
and Time Properties" dialog box.
5. If necessary, toggle the "Date and Time Format" between German (DE) and
US.
After you have changed the setting and closed the dialog box, the instrument
adopts the new date and time.
4.7 Protecting Data Using the Secure User Mode
During normal operation, the R&S FSV/A uses a solid-state drive to store its oper-
ating system, instrument firmware, instrument self-alignment data, and any user
data created during operation. If necessary, the solid-state drive can be removed
from the R&S FSV/A and locked in a secure place to protect any classified data it
may contain.
Redirecting storage to volatile memory
Alternatively, to avoid storing any sensitive data on the R&S FSV/A permanently,
the secure user mode was introduced (option R&S FSV/A-K33). In secure user
Protecting Data Using the Secure User Mode