Instrument Tour
R&S
®
FSVA3000/R&S
®
FSV3000
45Getting Started 1330.8073.02 ─ 03
Function key Assigned functions
[Marker ->] Used for search functions of the measurement markers (maxi-
mum/minimum of the trace).
Assigns the marker frequency to the center frequency, and the
marker level to the reference level.
Restricts the search area (Search Limits) and characterizes the
maximum points and minimum points (Peak Excursion).
Measurement and evaluation functions
[Meas] Provides the measurement functions.
Measurement of multicarrier adjacent channel power (Ch Power
ACLR)
Carrier to noise spacing (C/N C/N
0
)
Occupied bandwidth (OBW)
Spectrum emission mask measurement (Spectrum Emission
Mask)
Spurious emissions (Spurious Emissions)
Measurement of time domain power (Time Domain Power)
Signal statistics: amplitude probability distribution (APD) and
cumulative complementary distribution function (CCDF)
Third-order intercept point (TOI)
AM modulation depth (AM Mod Depth)
[Meas Config] Used to define measurement configuration.
[Lines] Configures display lines and limit lines.
[Input/Output] Displays softkeys for In/Out functions.
Measurement start functions
[Run Single] Starts a single new measurement (Single Sweep Mode).
[Run Cont.] Starts a continuous measurement (Continuous Sweep Mode).
Function execution (in navigation controls area)
[Undo] Reverts last operation
[Redo] Repeats previously reverted operation.
5.1.7 Keypad
The keypad is used to enter alphanumeric parameters, including the correspond-
ing units (see also Chapter 7.3.2, "Entering Alphanumeric Parameters",
on page 98). It contains the following keys:
Front Panel View
To Next Page
Loading...
