Rohde & Schwarz NRP-Z11 - Putting into Operation

R&S NRP-Z11/21/31/41/61/211/221 Table of Contents Chapter 1
1137.7470.12 I-1.1 E-8
Table of Contents
1 Putting into Operation ......................................................................................................1.1
Unpacking the power sensor ..........................................................................................................1.1
Connecting the power sensor .........................................................................................................1.1
Operation with the R&S NRP/NRP2 power meter .........................................................................1.2
Connecting the power sensor .....................................................................................................1.2
PC control .........................................................................................................................................1.2
Hardware and software requirements ........................................................................................1.2
Operation via the R&S NRP-Z4 passive USB adapter ...............................................................1.4
Connecting the sensor to the DUT .............................................................................................1.4
Operation via the Active USB Adapter R&S NRP-Z3 .................................................................1.4
Operation via the R&S NRP-Z5 Sensor Hub ..............................................................................1.5
Equipment Supplied and Alternative Accessories ..........................................................1.5
Ports and LEDs ...............................................................................................................1.6
Test Setup .......................................................................................................................1.7
Troubleshooting ..............................................................................................................1.9
Operation with other Rohde & Schwarz test instruments..........................................................1.10
Hardware and software requirements ...........................................................................1.10