R&S NRP-Z11/21/31/41/61/211/221 Program module "Terminal"
1137.7470.12 3.1 E-7
3 Manual Operation
The previous section describes the Power Viewer program module supplied with the instrument. This
module simplifies the most frequently used function of a power meter – measuring the average power of
an RF signal of almost any modulation. Other program modules are also part of the supplied equipment
and can be selected in the Start menu:
• Power Viewer: A detailed description of this virtual power meter module is provided in
section 2.
• Terminal: Program module for sending commands and command sequences to the
sensor and for displaying measurement results, status information and
other data from the sensor
• Firmware Update: Program module for updating the sensor firmware
• Update S-Parameters: Program module for loading an s-parameter table into the sensor
Program module "Terminal"
Main control elements
With the USB terminal, commands and command sequences can be sent to the sensor in two different
ways:
• Commands are entered in the Input field (Fig. 3-1). Consecutive commands can be entered as
separate lines, one below the other. The buttons associated with the Input field are described in
Table 3-1.
• Commands or command sequences are stored in command files. Command files are created with a
text editor, for instance, and then stored. They can be called as often as required (Fig. 3-2). The
buttons of the Command File field are described in Table 3-2.
Fig. 3-1 Sending commands using the Input field
To Next Page
Loading...
