R&S NRP-Z91 Overview
1168.8579.12 2.1 E-1
2 Virtual Power Meter
You will find the NrpFlashup program that enables you to operate the power sensor with a PC under
Windows™ on the CD-ROM that accompanies the power sensor. The program comprises several
modules which can be started centrally via the Windows™ start-menu entry NRP Toolkit.
This section describes the Power Viewer program module. This is a virtual power meter which only
uses a cut-down set of the power sensor’s functions. This means that after an extremely brief
familiarization period, you can perform measurements.
The other modules in NrpFlashup are described in Chapter 3 of the operating manual (Terminal and
Update S-Parameters modules) or in the service manual (Firmware Update module).
Overview
Start the virtual power meter using the NRP Toolkit – Power Viewer start-menu entry. The Power
Viewer program window is displayed (Fig. 2-1).
Fig. 2-1 Power Viewer – virtual power meter
The result display occupies most of the program window. The result, unit and additional power sensor
status information are displayed. The serial number is displayed in the bottom right. The program
window also contains animated buttons and entry fields (see Table 2-1 and Table 2-2).
To Next Page
Loading...
