Rohde & Schwarz R&S NRP-Z91 - List of Remote-Control Commands

R&S NRP-Z91 Remote Control - Commands
1168.8579.12 6.23 E-3
List of Remote-Control Commands
The remote-control commands of the R&S NRP-Z91 have a syntax based on standard SCPI 1999.0,
but they comply with it only to a limited extent.
Table 6-8 List of remote-control commands
Command Parameter Unit Default setting Page
* Commands
*IDN? 6.2
*RST 6.2
*TRG 6.2
*TST? 6.2
CALibration Commands
CALibration:DATA[?]
<calibration data set as definite length
block>
6.3
CALibration:DATA:LENGth? Bytes 6.3
CALibration:ZERO:AUTO[?] OFF | ON | ONCE OFF (fixed) 6.4
SENSe Commands
SENSe:AVERage:COUNt[?] 1 to 65536 4 6.6
SENSe:AVERage:COUNt:AUTO[?] OFF | ON | ONCE ON 6.6
SENSe:AVERage:COUNt:AUTO:MTIMe[?] 0.01 to 999.99 s 4.0 6.7
SENSe:AVERage:COUNt:AUTO:NSRatio[?] 0.0 to 1.0 dB 0.01 6.7
SENSe:AVERage:COUNt:AUTO:RESolution[?] 1 to 4 3 6.7
SENSe:AVERage:COUNt:AUTO:TYPE[?] RESolution | NSRatio RESolution 6.7
SENSe:AVERage:RESet 6.7
SENSe:AVERage:STATe[?] OFF | ON ON 6.7
SENSe:AVERage:TCONtrol[?] MOVing | REPeat REPeat 6.8
SENSe:CORRection:DCYCle[?] 0.001 to 99.999 % 1.0 6.8
SENSe:CORRection:DCYCle:STATe[?] OFF | ON OFF 6.8
SENSe:CORRection:OFFSet[?] –200.0 to 200.0 dB 0.0 6.9