Rohde & Schwarz SMAB-K24 - Page 654

Remote Control Commands
R&S
®
SMA100B
652User Manual 1178.3834.02 ─ 05
Options: R&S SMAB-B28
Manual operation: See " Sweep Time " on page 174
[:SOURce<hw>]:SWEep:MARKer:OUTPut:POLarity <Polarity>
Selects the polarity of the marker signal.
Parameters:
<Polarity> NORMal | INVerted
NORMal
Marker level is high when after reaching the mark.
INVerted
Marker level is low after reaching the mark.
*RST: NORMal
Example: See [:SOURce<hw>]:SWEep[:FREQuency]:MARKer<ch>:
FREQuency on page 652.
Options: R&S SMAB-B28
Manual operation: See "Marker Polarity" on page 182
[:SOURce<hw>]:SWEep[:FREQuency]:MARKer:ACTive <Active>
Defines the marker signal to be output with a higher voltage than all other markers.
Parameters:
<Active> NONE | M01 | M02 | M03 | M04 | M05 | M06 | M07 | M08 | M09 |
M10
*RST: NONE
Example: See [:SOURce<hw>]:SWEep[:FREQuency]:MARKer<ch>:
FREQuency on page 652.
Options: R&S SMAB-B28
Manual operation: See " Active Marker " on page 182
[:SOURce<hw>]:SWEep[:FREQuency]:MARKer<ch>:FREQuency <Frequency>
Sets the frequency of the selected marker.
Suffix:
<ch>
.
1 to 10
Marker
Parameters:
<Frequency> float
Increment: 0.01
*RST: 100 + n* 100
SOURce Subsystem