R&S SMU200A Troubleshooting
1007.9845.82 3.19 E-6
Normal action
Error and error cause
This procedure can be interrupted using the "PAUSE" key on the
connected external keyboard; pressing any other key continues
execution of the program.
The following messages are displayed:
If this hard disk entry is missing,
the hard disk may be faulty.
Normal action
Error and error cause
The PCI hardware test is displayed in the lower half
of the screen. All modules found during the test are
displayed with their names and PCI device IDs. The
Device Class column lists the types of PCI device.
The DACIF is listed as “Unknown PCI Device,
Vendor ID 162F, Device ID 1311“.
Option R&S SMU-B14 (Fader) is listed as 'Unknown
PCI Device, Vendor ID 104C, Device ID A106'.
After a cold start, the UNICOD module is not listed.
After a warm start and prior successful initialization
of the UNICOD module it is listed as “Unknown PCI
Device, Vendor ID 162F, Device ID 1312”.
If the line "Unknown PCI Device" is missing,
the DACIF board has not been identified and
the measuring application cannot be started. If
the remaining PCI devices have all been
identified, the DACIF board must then be
replaced.
If the Vendor ID and/or Device ID of the
“Unknown Devices” is incorrect, either the
module concerned or the motherboard is
defective.
Note: The connectors on the motherboard
must be checked for bent terminal pins.
After this test, the BIOS has been loaded and the
operating system is started.
Updating ESCD … Success
Verifying DMI POOL Data .......... Update Success
The message “DISK BOOT FAILURE,
INSERT SYSTEM DISK AND PRESS ENTER”
at this point indicates that the contents of the
hard disk are not correct.
In this case, the fault is either on the hard disk
or on partition C: of the hard disk, i.e. Windows
XP Embedded must be reinstalled or the hard
disk changed. Please contact your Rohde &
Schwarz representative.
To Next Page
Loading...
