Rohde & Schwarz SMU200A - Replacing the Lithium Battery 0858.2049 on the Front Module Controller

R&S SMU200A Module Replacement
1007.9845.82 3.55 E-6
Replacing the Lithium Battery 0858.2049 on the Front
Module Controller
(See chapter 5, parts list and drawing1141.2005.01)
The lithium battery is accommodated on the front module controller board behind the front panel.
Caution!
- Lithium batteries must not be exposed to high temperatures or fire.
- Keep away from children.
- If the battery is replaced improperly, there is danger of explosion. Only
replace the battery by an R&S type (See chapter 5, spare parts list
1141.2057.01, item 775 for type FMR5 and item 776 for type FMR6).
- Lithium batteries are hazardous waste and must be disposed of in
dedicated containers.
 Remove the front panel.
 Carefully lift and pull out the battery (for position, see drawing in "Removing the Front Panel"
section).
Note: 3.4 V lithium battery (
 20 mm * 3 mm , type CR2032) R&S Order No. 0858.2049.00
Warning!
Do not short-circuit the battery!
 Insert new battery into holder below the spring.
Note: The positive pole (+) of the battery points up.
 Install front panel again.