R&S SMU200A Measuring Equipment and Accessories
1007.9845.82 1.1 E-12
1 Checking the Rated Characteristics
This performance test describes the steps for testing the R&S SMU Signal Generator family and the
installed options with respect to function and compliance with specifications.
The R&S SMU Signal Generator family comprises the following instruments:
Table 1-1 Vector Signal Generator Family
Instrument R&S Order No.
R&S SMU200A 1141.2005.02
R&S SMATE200A 1400.7005.02
R&S SMJ100A 1403.4507.02
In the following, the term DUT (Device Under Test) is used for any signal generator of this family.
All option names are abbreviated in such a way that only the extension is given. For example, option
R&S B106 denotes R&S B106, R&S B106 or B106 depending on the instrument.
The tests to be performed depend on the installed options. The values are given in the data sheet of the
respective instrument.
Measuring Equipment and Accessories
Table 1-2 Measuring equipment and accessories
Item Type of Instrument Required Characteristics Suitable Instrument R&S Order No.
1 Frequency counter
(included in item 24)
1 Hz to RF
max
,
resolution 0.1 Hz
2 Reference source for
SSB noise measurements
Low SSB noise,
frequency range up to RF
max
Reference Synthesizer 1158.2878
3 Storage oscilloscope 300 M samples/s, two channels
4 Controller Industry standard PC/XT/AT
with IEC-60625 interface and
USB interface
R&S PSM17 1116.5004.70
5 Signal generator 0.1 MHz to RF
max
R&S SMU with options
R&S B106, -B10, -B13, -B31,
-K43, -K61, - B17
1141.2005.02
6 Phase noise test assembly Mixer: 10 MHz to RF
max
,
branching filter 2 MHz,
preamplifier with gain of approx.
30 dB, input noise < 2 nV (1 Hz),
DC decoupling after mixer
for oscilloscope
7 Oscilloscope
(usually included in item 3)
Bandwidth > 100 MHz,
two channels with DC coupling
8 RF power meter 100 kHz to RF
max
R&S NRVS with
R&S NRV-Z5
1020.1809.02
0828.3818.02
10 Low-noise preamplifier 100 kHz to RF
max
,
gain > 20 dB,
noise figure < 10 dB
To Next Page
Loading...
