Rohde & Schwarz SMU200A - Installing a New Digital Module; Removing a Digital Board; Replacing the Digital Module DAC Board, A580 - Option B13

Module Replacement R&S SMU200A
1007.9845.82 3.52 E-6
Table 3-4 Position of digital boards in R&S SMU200A
In other devices of the family the relative positions of the boards are the same, only slot numbers differ.
Slot 6D
DAC
Interface
a
nd
DAC Board
DAC
Interface
a
nd
DAC Board
DAC
Interface
a
nd
DAC Board
DAC
Interface
a
nd
DAC Board
DAC
Interface
a
nd
DAC Board
DAC
Interface
a
nd
DAC Board
DAC
Interface
a
nd
DAC Board
DAC
Interface
a
nd
DAC Board
DAC
Interface
a
nd
DAC Board
DAC
Interface
a
nd
DAC Board
Slot 5D
Universal
Coder
Fading
Simulator
Fading
Simulator
Universal
Coder
Fading
Simulator
Fading
Simulator
Universal
Coder
Universal
Coder
Fading
Simulator
Fading
Simulator
S
lot 4D
Universal
Coder
Fading
Simulator
Extension
U
niversal
Coder
U
niversal
Coder
F
ading
Simulator
Extension
I
Q Bridge Universal
Coder
U
niversal
Coder
F
ading
Simulator
Extension
Slot 3D
Universal
Coder
Universal
Coder
U
niversal
Coder
I
Q Bridge IQ Bridge Universal
Coder
U
niversal
Coder
Slot 2D
Universal
Coder
IQ Bridge IQ Bridge IQ Bridge Universal
Coder
Slot 1D
Baseband
Input
B
aseband
Input
B
aseband
Input
B
aseband
Input
Removing a Digital Board
 Switch off the instrument and pull the mains plug.
 Remove instrument covers 1 and 2.
 Pull out the board towards the top of the instrument using the pull-out levers.
Installing a New Digital Module
 Plug the new board into the instrument. Be sure to plug in to the limit stop.
 Reinstall instrument covers 1 and 2.
Replacing the Digital Module DAC Board, A580 - Option B13
Removing the Module
 Loosen 6 screws (0041.1660) on the back of the DAC interface board. (Slot 6D)
 Then carefully remove the cooling cover of the DAC board.
 Unscrew another 6 screws (1148.2600 with washers 0082.4640 and 0005.0267) on the component
side near the connectors of the DAC board.
 The DAC board can be removed now.