Rohde & Schwarz SMU200A - Test Assemblies; Standard Test Assembly for Analog Modulations; Test Assembly for Residual

R&S SMU200A Test Assemblies
1007.9845.82 1.3
E-12
Test Assemblies
Standard Test Assembly for Analog Modulations
Test equipment - RF analyzer (Table 1-1, item 7)
- Signal generator (Table 1-1, item 5)
Test setup The RF analyzer is used as a modulation analyzer. The signal generator
is used as modulation source in case of external modulation.
RF analyzer
10 MHz Reference
RF
Signal
Generator
LF
DUT
LF
Test Assembly for Residual AM
Test equipment - RF analyzer (Table 1-1, item 7)
- Zero Bias Schottky Detecor (Table 1-1, item 28)
- Low Noise Preamplifier 10 Hz – 30 kHz, >30 dB Gain
- Signal generator (Table 1-1, item 5)
Test setup
RF analyzer
10 MHz Reference
RF
SMU
Detector
Preamp.