Roland Fantom-S88 - Splitting the Keyboard to Play an Ensemble (Split)

13
Try Out the Sounds
6. Play the keyboard.
The two patches assigned to Parts 1 and 2 sound together. If you uncheck “KBD,” that part will
no longer sound.
Use [CURSOR] to move the cursor to “KBD,” press [DEC] to remove the check mark from “KBD,”
and move the cursor away from that part; you will no longer hear the sound of that part.
Use [CURSOR] to move the to part 1 or part 2 and play just one of the parts to hear which
sounds are being layered.
Changing the Performance Settings
For details about how you can adjust the most important settings for a performance, refer to
the following pages of the owner’s manual.
• Selecting the parts that’ll sound → (Owner’s Manual; p. 79)
• Switching the patch assigned to a part → (Owner’s Manual; p. 79)
• Adjusting volume/pan/pitch → (Owner’s Manual; p. 85)
• Applying effects to the performance → (Owner’s Manual; p. 178)
• Saving a performance whose settings you’ve modified → (Owner’s Manual; p. 96)
Splitting the Keyboard to Play an Ensemble (Split)
Performances in which different patches play in different parts of the keyboard are called split .
A split performance is actually a type of layer in which each sound is assigned to a specified
keyboard part.
Here we will explain how to select the “PRST: 62 Ensemble Pfm” performance, which contains
settings for a divided keyboard range, and use the arpeggiator and rhythm patterns to produce
a guitar and drum ensemble.
1.
Press [LAYER/SPLIT] to select the performance “PRST: 62 Ensemble Pfm.”
(p. 12)
fig.Q-15.e
In this performance, the key range settings are shown below.
Part1: C2–B3 (backing part)
Part2: F6–C7 (rhythm part)
Part3: C4–E6 (solo part)
fig.Q-05-09.e
The arpeggiator is assigned to part 1, and the rhythm patterns are assigned to part 2.
You may notice that “PAD” is shown below the part number; this means that part 2 is the part
that will sound when you play the pads.
In Performance mode, the
arpeggiator can be applied to
one part. To select the part to
which the arpeggiator will
apply, press ARPEGGIO/
RHYTHM [SELECT/EDIT]/[3
(Arp)] to display the
Arpeggiator screen, and check
the “Arp Part” setting. Press
[EXIT] to return to the previous
screen.
Key range for part
Part 1: Backing part
Part 3: Solo part
Part 2: Rhythm part
Fantom-s_e.book 13 ページ ２００３年５月１５日 木曜日 午後１時２５分