29
Using Skip Back Sampling to Sample a
Favorite Phrase (Skip Back Sampling)
Sometimes you may want to preserve a nice phrase that you happened to play a bit earlier. In
such cases, you can use the
Skip Back Sampling
function to sample sounds that were played
earlier in time.
When you execute
Skip Back Sampling
, the phrase you played previously will be captured as
a sample. You can assign this sample to a pad and play it from the pad.
fig.Q-SMPL08
Button lit:
Skip Back Sampling is possible.
Button unlit:
Skip Back Sampling is not possible.
Button blinking:
After sampling, the sample is being edited by adjusting the loop point, etc.
1.
Press [PATCH/RHYTHM] to access the patch play screen.
2.
Perform by playing phrases on the keyboard or striking the pads.
3.
Press [SKIP BACK SAMPLING] located at the left of the pads.
The following screen will appear, and Skip Back sampling will be executed.
Sampling will stop automatically, and the Sample Edit screen will appear.
fig.Q-SMPL01_50
4.
Press [8 (Preview)] to listen to the sample.
It will continue playing while you hold down the button.
The sampled phrase will be added as a sample to the sample list in a dedicated storage location
called “sample memory.”
5.
Press [SAMPLE LIST] to display the Sample List screen.
fig.Q-SMPL02_50
The highlighted sample is the sample that was captured by Skip Back Sampling.
What is a sample? A sample
contains the waveform data
sampled by the Fantom-S. In
addition to the actual
waveform data itself, a sample
also contains parameters such
as start point, loop start, and
loop end.
With the factory settings, Skip
Back Sampling will capture the
previous ten seconds of your
performance. You can change
the setting so that Skip Back
Sampling will capture as much
as the previous forty seconds
of your performance.
Fantom-s_e.book 29 ページ ２００３年５月１５日 木曜日 午後１時２５分
To Next Page
Loading...
