Roland Fantom-S88 - Playing and Recording Rhythm Part

39
Creating a Song
4. Set the parameters of the Realtime Rec Standby window as shown below.
Press or to move the cursor to each parameter, and turn the VALUE
dial or use [INC] [DEC] to set the value.
• Rec Track: AUTO
A location where recording occurs is called a “track.” Specify the recording-destination phrase
track. If you select “Auto,” a location where recording occurs is called a “track.” This setting
specifies the recording-destination phrase track. If this is set to “Auto,” the phrase track of the
same number as the part currently selected for the keyboard will be chosen automatically.
• Rec Mode (recording mode): MIX
Selects how recording will occur. If you specify “MIX,” the newly-recorded material will be
added to any performance that is already recorded on the recording-destination track without
erasing it.
• Count In: WAITE NOTE
Selects how recording will begin. If you select “WAITE NOTE,” recording will begin when you
play the keyboard or press the Hold pedal.
• Loop/Punch: LOOP (2 MEAS)
When repeatedly recording over a specified region, this specifies the length of that region. If
you specify “2 MEAS,” you will be able to repeatedly record over a two-measure region
without stopping.
• Input Quantize: GRID
This function automatically corrects the timing at which you play keys or pads, so that they will
be aligned to precise intervals of time. You can quantize while recording. If you set this to
“GRID,” the notes will be recorded at precise timing intervals.
fig.Q-46a_50
• Grid Resolution: 1/16 ( )
This setting is used by grid quantization. Set this to the shortest of the note values that you will
be inputting.
* Parameters other than the above will not be used in this example, so you do not need to set
them.
Playing and Recording Rhythm Part
* Make sure that the parameters of the Realtime Rec Standby window are set correctly.
1.
In the Realtime Rec Standby window, press [8 (Start)], and then press [7
(Rehearsal)].
In the Realtime Recording window, a check mark ( ✔ ) will be applied to [7 (Rehearsal)],
indicating that the Rehearsal function is on. The Rehearsal function temporarily disables
recording during realtime recording. This is convenient when you want to check the sound that
you will record next during loop recording, or when you want to practice the phrase that you
will record next.
When the Rehearsal function is on, the [REC] indicator will blink.
fig.Q-46b_50
Fantom-s_e.book 39 ページ ２００３年５月１５日 木曜日 午後１時２５分