Roland HandSonic HPD-15 - Settings for the Click, and Others

61
Chapter 3 Recording Your Performance (Sequencer)
Chapter 3
Settings for the Click, and others
fig.3-09.e
Checking the Remaining Amount of Memory
Changing the Pattern Name
CLICK
MEMORY
PATTERN NAME
Available
Specifying the Interval
Selecting a Sound
Intrvl
Inst
1/2, 1/4, 3/8, 1/8, 1/12, 1/16,
3-2 Son, 2-3 Son, 3-2 Rumba,
2-3 Rumba, 6/8 Clave
Click, Sticks, Metronome,
Claves, WoodBlock, Triangle,
Cowbell, Conga, TalkingDrum,
Maracas, Cabasa, Cuica,
Agogo, Tambourine, Snaps,
909Snare, 808Cowbell
0 – 127
Adjusting the Volume
Level
Pan
Adjusting the Pan (Localization)
L63 – Center – R63
Reverb Send Adjusting the Depth of Reverb 0 – 127
Mode
Turning the Click On/Off
OFF, REC Only,
REC/PLAY
PlyCountIn
Adding a Count Sound Before Playback
OFF, 1Meas, 2Meas
RecCountIn OFF, 1Meas, 2Meas
Adding a Count Sound Before Recording
(only displayed)
(up to 10 characters)
Using the reverb makes the click more comfotable to listen to.
OFF: Click doesn't sound while the playback /recording.
OFF: Playback will begin without a count-in.
OFF: Recording will begin without a count-in.
The remaining amount of memory is displayed.
How to changing the name is same as naming a patch.
Refer to "Naming a Patch" (p. 55).
Category Parameter Value
REC/PLAY: Click sounds while the playback /recording.
REC Only: Click sounds while the recording.
2Meas: Playback begins after a 2-measure count-in.
1Meas: Playback begins after a 1-measure count-in.
2Meas: Recording begins after a 2-measure count-in.
1Meas: Recording begins after a 1-measure count-in.