Roland HandSonic HPD-20 - Page 30

Sound Editing
30
EQ
This divides the sound of the entire kit into low, mid, and high frequency regions, allowing you to boost or cut the volume of
each region.
You can boost the low range to make the sound more powerful, or boost the high range to make the sound brighter.
Applying EQ to a kit
1. Choose MENU g FX g EQ.
The KIT EQ screen will appear.
2. Press the [F3] (EQ) button to turn EQ on.
If this is o, EQ will not be applied.
3. Use the cursor [ ] [ ] [ ] [ ] buttons to select a parameter, and use the value knob to edit the value.
Parameter Explanation
Q
Adjusts the width of the frequency region selected by “Freq.”
Higher values make the region narrower, producing a more distinctive sound.
* This is available only for MID.
Freq
Selects the frequency range at which the volume will be boosted or cut.
Lower values aect a lower frequency range; higher values aect a higher frequency range.
* The available range diers between LOW/MID/HIGH.
Gain
Species the amount by which the volume is boosted or cut.
Positive (“+”) values boost the frequency region specied by “Freq.”
Negative (“-”) values cut the frequency region specied by “Freq.”
If you don’t want to apply an eect, set this to “0.”
KIT EQ screen