ENTERING A PATTERN WITH
AUTOMATICALLY ADVANCING STEPS
1. Hold down the SEQUENCER [EDIT] button and press the [START] button.%
Step button [1] blinks, the display indicates “S 1,” and the unit is in step entry mode. %
2. Press the KEYBOARD [NOTE] button to make it blink. %
3. Use step buttons [1]–[12] to enter the pitch. %
The gate time value will be 50. %
4. The step advances automatically each time you play a note. When you have entered 16 steps, entry
mode ends. %
If using the K-25m enter notes using the keyboard of the K-25m instead of steps 2–3. !
ENTERING/EDITING NOTES
Press the SEQUENCER [EDIT] button to make it light. %
Set the [NOTE/GATE] switch to the “NOTE” position. %
Hold down the step button for which you want to enter a note, and use the [VALUE] knob to select the
note number. %
The display shows the note number. %
You can also select a note number by holding down a step number and playing a note on the keyboard
of the K-25m. %
By holding down multiple step buttons and turning the [VALUE] knob, you can enter the same note
number for all of the buttons that you’re holding down. %
A lit step button indicates note-on, and an unlit step button indicates note-off. !
ENTERING/EDITING THE GATE TIME
1. Press the SEQUENCER [EDIT] button to make it light. %
2. Set the [NOTE/GATE] switch to the “GATE” position. %
3. While holding down the step button at which you want to enter a gate, use the [VALUE] knob to select
the gate time. %
The display indicates the value. %
By holding down multiple step buttons and turning the [VALUE] knob, you can enter the same gate time
for all of the buttons that you’re holding down. !
To Next Page
Loading...
