SYSTEM SETTINGS
1. Hold down the ARPEGGIO [ON/OFF] button and select a parameter by pressing one of the numeric
buttons shown in the following table. !
2. Use the [VALUE] knob to select the value.%
3. Press the ARPEGGIO [ON/OFF] button once again to confirm the value and exit system settings. !
BUTTON# PARAMETER# # VALUE# # EXPLANATION!
[1]# # Master Tune# # 433-448hz# Specifies the master tuning. !
# # # # # # # Default 440 Hz!
[2]# # MIDI Channel# 1-16# # # Specifies the MIDI transmit/!
# # # # # # # receive channel (1-16)!
[3]# # MIDI Clock # # At (Auto)# If MIDI clock is being input to the MIDI !
# # Source# # # # # IN connector or the USB port, the !
# # # # # # # JU-06A’s tempo will automatically !
# # # # # # # synchronize to MIDI clock (default).!
# # # # # INT# # The JU-06A operates at the tempo !
# # # # # (Internal)# specified on the unit itself. Choose the !
# # # # # # # “INTERNAL” setting if you don’t want to !
#######synchronize to an external device.%
# # # # # MID# # Always synchronize to the MIDI clock !
# # # # # (MIDI)# # received from the MIDI IN connector.!
%
# # # # # USB# # Always synchronize to the MIDI clock !
# # # # # # # received from the USB port.%
[4]# # Transpose # # -6 - 5# # Transposes the keyboard range in !
# # *2# # # # # semitones.%
#######Default: 0 !
[5]# # Key Velocity # # Specifies how the sound engine responds to velocity !
# # *1# # # data (the force with which you play a note).%
# # # # # * This setting also applies to the MIDI output when !
# # # # # you play the K-25m. !
# # # # # TCH# # The sound engine responds to velocity !
# # # # # (Touch)# data. !
#!
# # # # # 64# # Regardless of the velocity, the sound !
# # # # # # # engine always operates with a fixed !
# # # # # # # value (64 or 127).%
# # # # # 127# # Default: 127!
To Next Page
Loading...
