ENTERING A TIE
1. Press the SEQUENCER [EDIT] button to make it light. %
2. Hold down the step button for which you want to enter a tie, and press the SEQUENCER [EDIT]
button. %
You can enter a tie for the following step as well by pressing the SEQUENCER [EDIT] button again. If you
turn a step button off, that step’s tie is deleted. !
SAVING
If you modified the settings, the modified settings are lost if you turn off the power or select another
patch, chord memory, or pattern.%
If you want to keep the changes that you made, perform the Write operation. !
# # # # # # * KEYBOARD and ARPEGGIO settings are not saved. !
SAVING A PATCH !
If you modify the patch settings, a decimal point appears in the display. 1-1. !
1. Press the save-destination BANK [1 (5)]–[4 (8)] button.%
Each time you press the same bank button, you alternate between banks 1–4 and 5–8.%
To select banks 5–8, you can also hold down the bank (5–8) that you want to select and press a different
bank button. %
2. Long-press the save-destination PATCH [1]–[8] button. When the data is saved, the indicator blinks. %
KEYBOARD and ARPEGGIO settings are not saved in the patch. !
SAVING A CHORD MEMORY !
If you modify the chord memory settings, a decimal point appears in the display. c 1. !
1. Press the [NOTE] button to make it go dark. %
2. Hold down the [CHORD] button and long-press a step button [1]–[16]. %
When the data is saved, the indicator blinks. !
To Next Page
Loading...
Need help?
General
Weight and Dimensions
